Porsche Hatchback Panamera (970, 2010–2012) Camshaft Adjuster Bolt Recall
What this problem usually means
Panameras of 2010-2012 (970, V6 and V8, shared with the 2011 Cayenne S/Turbo) are under NHTSA safety recall 17V-368 (Porsche AH08, 18,005 vehicles across the Panamera and the 2011 Cayenne S/Turbo combined): the bolts holding the camshaft adjusters could come loose inside the engine, one bank can stop running and the engine can stall, with sudden rough running and a check-engine light as the warning. Dealers replace the fastening screws free of charge.
Likely causes
- Camshaft adjuster fastening bolts loosening (2010-2012 V6/V8) → Shop the camshaft adjuster bolts at Amazon
- Bolt material/fitment defect covered by campaign AH08
- Secondary timing damage if a loose adjuster is driven on
How to fix it — step by step
- Check your VIN for recall AH08 / 17V-368 and confirm it was completed
- Treat sudden rough running or a stall on a 2010-2012 car as a stop-and-check event
- Book the free dealer remedy (replacement fastening screws)
- Ask for the recall paperwork if buying - an undone car is a hard negotiate or walk-away
- Do not authorise unrelated engine parts until recall status is known
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the camshaft adjuster bolts.
Parts that commonly fix it
- camshaft adjuster bolts - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.