Porsche Coupe 911 (996/997.1, 1999–2008) Bore Scoring and Oil Consumption
What this problem usually means
Cylinder bore scoring affects 1999-2008 911s (996 and 997.1, M96/M97 flat-six, with the 3.6 and 3.8 engines most often cited - the 997.1 Carrera S 3.8 is the classic case): deep scratches form in the cylinder walls, cutting compression and raising oil use until a rebuild with sleeved cylinders is needed. Unlike an IMS failure it usually builds slowly and warns first - rising oil consumption, ticking or tapping at idle, and one tailpipe noticeably sootier than the other. The 997.2's 9A1 engine suffers from it far less often.
Likely causes
- Cylinder surface (Lokasil) coating wear and piston skirt scuffing
- Cold starts and short trips accelerating bore wear
- Dirty injectors and fuel wash cited among contributing causes
- Low-tension ring/oil patterns debated as a contributing factor
How to fix it — step by step
- Compare soot on the left and right tailpipes and log oil top-ups between services
- Send an oil sample for analysis - rising iron, aluminium or silicon supports the diagnosis
- Get a borescope inspection (specialists scope from below, where scoring starts) before buying any 997.1 Carrera S
- Check for ticking at idle and misfire codes
- If scoring is heavy, the fix is a rebuild with sleeved cylinders - internal engine work; price it before buying the car
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the cylinder liners.
Shop the cylinder liners at Amazon
Also tied to this fault: pistons - Shop at Amazon; engine oil - Shop at Amazon
Parts that commonly fix it
- cylinder liners - Shop at Amazon
- pistons - Shop at Amazon
- engine oil - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.