Philips Air purifier AC0850 Filter replacement alert (red)
What this problem usually means
The filter replacement alert lights up red: the NanoProtect Series 2 filter (FY0293) is almost expired (healthy air protect lock). If it is not replaced in time, the alert starts flashing, the appliance stops operating and locks.
Likely causes
- Filter lifetime nearly or fully expired
- Appliance locked because an expired filter was kept in use
How to fix it — step by step
- Turn the appliance off and unplug it.
- Rotate the base anti-clockwise to remove it.
- Pull the filter out of the appliance and discard it.
- Remove all packaging from the new NanoProtect Series 2 filter (FY0293) and put the filter into the appliance. → Shop the nanoprotect series 2 filter (fy0293) at Amazon
- Reattach the base by rotating it clockwise.
- Plug the appliance in and press the power button to switch it on.
- Press and hold the mode switch / filter reset button for 3 seconds to reset the filter lifetime counter. If the alert still shows after replacement, hold the mode switch button for 3 seconds until the alert disappears.
- Wash your hands after handling the filter.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the NanoProtect Series 2 filter (FY0293).
Parts that commonly fix it
- NanoProtect Series 2 filter (FY0293) - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.