Mercedes-Benz SUV GLC Oil leak from camshaft adjuster magnet
What this problem usually means
The GLC 300's M274 (and later M264) four-cylinder uses camshaft adjuster magnets whose internal seals harden with heat; engine oil then seeps through the solenoid into its electrical connector and can wick along the wiring harness toward a control unit. Replacing the magnets and dealing with the oily connector early prevents the expensive version of this fault.
Likely causes
- Camshaft adjuster magnet seal hardened with heat → Shop the camshaft adjuster magnet at Amazon
- Oil wicking through the wiring harness
How to fix it — step by step
- Check the magnet connectors at the front of the engine for oil
- Scan for camshaft/timing codes
- Replace the leaking magnet(s) and clean the connector
- Inspect the harness for oil travel toward the ECU
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the camshaft adjuster magnet.
Parts that commonly fix it
- camshaft adjuster magnet - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.