Mercedes-Benz SUV GLC (X253, 2016–2019) Camshaft Adjuster Rattle At Startup

What this problem usually means

The GLC300's M274 four-cylinder (2016-2019, X253) wears its camshaft adjusters, and the timing chain tensioner bleeds down while the car is parked, so owners hear a 1-2 second rattle at startup, see camshaft fault codes, and in some cases notice rising oil consumption. The rattle is the timing drive running slack until oil pressure builds. Because the adjusters, tensioner and chain wear together at the front of the engine, the repair replaces the worn timing components as a set.

Likely causes

  1. Camshaft adjuster internal wear
  2. Chain tensioner bleeding down overnight
  3. Timing chain stretch adding slack → Shop the timing chain at Amazon
  4. Low oil level or overdue oil changes worsening the rattle

How to fix it — step by step

  1. Record the cold-start rattle; 1-2 seconds that then disappears is the signature
  2. Have the camshaft codes read and monitor the oil level between services
  3. Ask whether the adjusters, tensioner and chain were assessed as a set
  4. Have the worn timing components replaced by a Mercedes specialist; this is internal timing work
  5. Confirm quiet cold starts and stable oil consumption after the repair

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Mercedes-Benz SUV GLC (X253, 2016–2019) problems

See all Mercedes-Benz GLC (X253, 2016–2019) codes & guides →