Mercedes-Benz SUV GLA (X156, 2014–2020) Timing chain stretch

What this problem usually means

The X156 GLA 200 (M270 1.6T) and GLA 250 (M274 2.0T) share the same core fault: timing chain stretch from around 80,000-100,000 km, announced by a cold-start rattle. The system uses both upper and lower chains, which must be replaced together; ignored, a stretched chain can jump a tooth and cause serious engine damage. A full timing kit replacement (chain, tensioner, guides and often the camshaft actuator solenoids) runs $1,500-$3,000+ at an independent specialist.

Likely causes

  1. Timing chain stretch at 80,000-100,000 km (M270/M274) → Shop the timing chain at Amazon
  2. Tensioner and guide wear letting the chain run slack

How to fix it — step by step

  1. Cold-start the engine and listen for a rattle; a tick clearing in one to two seconds is marginal, anything longer needs investigation
  2. Scan for timing/camshaft codes and check for misfires
  3. Have the chains (upper and lower), tensioner and guides replaced together if stretch is confirmed - internal engine work
  4. Do not keep driving on a persistent rattle; a jumped tooth can destroy the engine

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Mercedes-Benz SUV GLA (X156, 2014–2020) problems

See all Mercedes-Benz GLA (X156, 2014–2020) codes & guides →