Mercedes-Benz Sedan E-Class (W212, 2012–2016) Camshaft Adjuster Rattle At Startup

What this problem usually means

On the W212 E-Class with the M276 V6 (2012-2016), the camshaft adjusters lose their locking pins and the chain tensioner bleeds down when the car sits, producing a 1-2 second rattle at startup and adjuster fault codes that keep returning after clearing. The rattle is the sound of the timing drive running slack until oil pressure arrives, so it is a wear diagnosis, not a noise to live with: left alone, the same wear progresses to timing faults under load.

Likely causes

  1. Camshaft adjuster locking pins worn
  2. Chain tensioner bleeding down while parked
  3. Timing chain wear adding slack to the system → Shop the timing chain at Amazon
  4. Low oil pressure at startup from low level or overdue oil

How to fix it — step by step

  1. Record the cold-start rattle; 1-2 seconds then silence is the documented pattern on this engine
  2. Have the adjuster codes read and note whether they return immediately after clearing
  3. Check oil level and service history before condemning parts
  4. Have the worn adjusters and tensioner replaced by a Mercedes specialist; this is internal timing work
  5. Confirm quiet cold starts and no returning codes over the following week

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Mercedes-Benz Sedan E-Class (W212, 2012–2016) problems

See all Mercedes-Benz E-Class (W212, 2012–2016) codes & guides →