Mazda SUV CX-5 Clunking noise over bumps
What this problem usually means
CX-5s can make clunking noises over bumps caused by torn front lower wishbone (control arm) rear bushes, typically appearing between 60,000 and 80,000 miles.
Likely causes
- torn front lower control arm rear bushings
How to fix it — step by step
- Drive slowly over bumps and note whether the clunk comes from the front
- Have an observer watch the front wheels for excessive fore-and-aft movement while the throttle is gently pulsed in gear with the handbrake on, as the source inspection describes
- Have a shop inspect the front lower control arm bushes for tearing on a lift → Shop the lower control arm at Amazon
- Replace the worn control arm bushings or arms and check wheel alignment → Shop the control arm bushing at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the control arm bushing.
Shop the control arm bushing at Amazon
Also tied to this fault: lower control arm - Shop at Amazon
Parts that commonly fix it
- control arm bushing - Shop at Amazon
- lower control arm - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.