Mazda SUV CX-5 (KF, 2018–2019) Engine Stalls While Driving

What this problem usually means

Certain 2018-2019 CX-5s with the cylinder-deactivation engine are under Mazda recall 3719F, NHTSA 19V497: a software error in the powertrain control module — specifically the hydraulic valve clearance adjuster programming that controls cylinder deactivation — may cause loss of engine power and an engine stall. Mazda's NHTSA-hosted dealer notice titles it a Safety and Emissions Recall covering 304,882 vehicles across the CX-5, Mazda3 and Mazda6, and the remedy is a free PCM reprogram.

Likely causes

  1. PCM software error in cylinder-deactivation HLA control
  2. Rocker arm moving out of place during deactivation changeover
  3. Stall under the specific driving conditions the faulty programming allows

How to fix it — step by step

  1. Check your VIN at nhtsa.gov/recalls for 19V497 and book the free PCM reprogram if it is open
  2. Do not misdiagnose a stall on an affected car as a fuel pump fault until the recall status is checked; the CX-5 has a separate fuel pump recall with similar symptoms
  3. If it stalls in traffic, shift to neutral, restart if possible and get to a safe place; repeated stalls mean stop driving it
  4. Confirm the recall shows complete for your VIN after the update

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Mazda SUV CX-5 (KF, 2018–2019) problems

See all Mazda CX-5 (KF, 2018–2019) codes & guides →