Mazda Sedan Mazda3 (4th gen, 2019) Engine Stalls While Driving

What this problem usually means

Certain 2019 Mazda3s with the cylinder-deactivation engine are under Mazda recall 3719F, NHTSA 19V497: inappropriate programming of the hydraulic valve clearance adjuster (HLA) software that controls cylinder deactivation and reactivation can cause loss of engine power and an engine stall. Mazda's dealer notice, hosted by NHTSA, titles 3719F a Safety and Emissions Recall and puts the combined CX-5, Mazda3 and Mazda6 population at 304,882 U.S. vehicles; the remedy is a PCM reprogram.

Likely causes

  1. Powertrain control module software error in the cylinder-deactivation HLA control
  2. Rocker arm / valve clearance adjuster moving out of position during deactivation changeover
  3. Stall during the specific driving conditions the faulty programming allows

How to fix it — step by step

  1. Check your VIN at nhtsa.gov/recalls for 19V497 before anything else; the PCM reprogram is free at a Mazda dealer
  2. Do not treat a stall on an affected car as a fuel or battery fault until the recall status is known
  3. If the engine stalls in traffic, shift to neutral, restart if it will, and move to a safe place; repeated stalls mean stop driving it until repaired
  4. Confirm the recall shows complete for your VIN after the dealer visit

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Mazda Sedan Mazda3 (4th gen, 2019) problems

See all Mazda Mazda3 (4th gen, 2019) codes & guides →