Mazda Sedan Mazda3 (3rd gen, 2014–2018) Rearview Camera Image Flickers Or Distorts
What this problem usually means
The rearview camera on 2014-2018 Mazda3s can show a flickering or distorted image, the subject of NHTSA safety recall 23V487 (236,100 vehicles across the Mazda3 and the 2016-2021 CX-3). Dealers inspect and replace the camera as needed and add a harness seal.
Likely causes
- Rearview camera failure producing a flickering or distorted image → Shop the rearview camera at Amazon
- Wiring harness connection at the camera without adequate sealing → Shop the camera wiring harness seal at Amazon
- Camera or harness deterioration with age and moisture exposure
How to fix it — step by step
- Check your VIN at nhtsa.gov/recalls for 23V487; the inspection, camera replacement and harness seal are free if your car is covered
- Test the image in daylight and at night; a distorted image is the documented symptom, not a dirty lens alone
- Keep using mirrors and a shoulder check while the camera is faulty rather than relying on the image
- Confirm the recall shows complete for your VIN after the dealer visit
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the rearview camera.
Shop the rearview camera at Amazon
Also tied to this fault: camera wiring harness seal - Shop at Amazon
Parts that commonly fix it
- rearview camera - Shop at Amazon
- camera wiring harness seal - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.