Maytag Front-Load Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 8 codes covered.
Shop Maytag Front-Load parts at RepairClinic or Amazon
- dET — The detergent cartridge is not detected in the dispenser (select models). If you use single-load doses of detergent, Maytag says this…
- F5 E2 — The door is not locking properly, so the washer will not start or continue the cycle.
- F7 E1 — A motor speed sensing error: the motor cannot achieve the correct speed for the cycle selected.
- F8 E2 — There is a problem with the dispenser system (select models).
- F9 E1 — Drain times are longer than expected, typically over eight minutes.
- Int — The cycle was paused or canceled. The washer may take 20 to 30 minutes to stop spinning and drain while this code is shown.
- LOC — Control Lock has been activated, so the controls are locked and the washer will not respond to most buttons.
- rL — Items were detected in the washer during the Clean Washer cycle (also shown as F34 on some models). The cleaning cycle must run empty.