Maytag Washer Front-Load and Top-Load HE Sd Error Code
What the Sd code means
There are too many suds in the washer (also shown as Sud). The washer pauses tumbling and extends rinsing to break down the suds, and it cannot spin water out properly until they clear.
Likely causes
- Too much detergent
- Non-HE detergent used
- No-splash or easy-pour bleach creating extra suds
- Restricted drain hose or standpipe
How to fix it — step by step
- Let the washer run its automatic suds-reduction and extra rinse routine
- Use only HE detergent, measured for the load size
- Check the drain hose is not kinked or clogged
- If you used no-splash bleach, switch to regular liquid bleach products
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the Sd code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Maytag manual is on Maytag's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.