LG Robot vacuum CordZero R9 Check the dust bin
What this problem usually means
Voice message played when the R9 detects that the dust bin or pre-filter is incorrectly installed.
Likely causes
- Pre-filter not installed correctly
- Dust bin not installed correctly
- Sensor does not recognize the pre-filter or dust bin
How to fix it — step by step
- Remove the pre-filter from the dust bin and reinstall it securely in its correct position with no gaps → Shop the pre-filter at Amazon → Shop the dust bin at Amazon
- Push the assembled dust bin fully into the robot vacuum until you hear a click
- Turn the main power switch Off, then back On to reset the sensor
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Dust bin.
Also tied to this fault: Pre-filter - Shop at Amazon
Parts that commonly fix it
- Dust bin - Shop at Amazon
- Pre-filter - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official LG manual is on LG's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.