Lexus SUV RX (AL10, 2012–2013) ABS and Stability Control Lights On - Recall 14V-054

What this problem usually means

Certain 2012-2013 RX 350s are under NHTSA safety recall 14V054000 (February 2014; 261,114 vehicles campaign-wide): an electrical component inside the brake actuator can develop higher resistance, lighting the VSC, ABS and traction control warnings and switching those systems off. The remedy is a free dealer update of the skid control ECU software — the actuator itself is not automatically replaced.

Likely causes

  1. Brake actuator electrical component resistance increase (recall defect) → Shop the brake actuator at Amazon
  2. Skid control ECU software needing the recall update → Shop the skid control ecu at Amazon
  3. Wheel speed sensor fault producing similar warning lights (rule out after recall check)

How to fix it — step by step

  1. Check your VIN at nhtsa.gov/recalls for campaign 14V054 if the ABS/VSC/traction lights are on together
  2. Book the free dealer software update if the recall is open
  3. Drive cautiously while the systems are disabled, since ABS and stability control may not intervene
  4. Have codes read if the lights persist after the update, to separate a sensor fault from the recall defect
  5. Confirm all three warning lights stay off after the remedy

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Lexus SUV RX (AL10, 2012–2013) problems

See all Lexus RX (AL10, 2012–2013) codes & guides →