Kenmore Dryer 110 Series (Whirlpool-Built) and 796 Series (LG-Built) PF Error Code
What the PF code means
Power failure on Kenmore 110-series (Whirlpool-built) and many 796-series Kenmore dryers: power was interrupted during a cycle. The dryer stops and shows PF until you restart it.
Likely causes
- House power outage
- Tripped breaker or blown fuse
- Loose power cord
How to fix it — step by step
- Check the breaker, fuse and power cord connection
- Wait until power is stable
- Press and hold START to restart the dryer
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the PF code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.
Related Kenmore Dryer 110 Series (Whirlpool-Built) and 796 Series (LG-Built) error codes
See all Kenmore 110 Series (Whirlpool-Built) and 796 Series (LG-Built) codes & guides →