Jeep SUV Wrangler (JK, 2012–2013) Engine misfiring

What this problem usually means

The 2012-2013 Wrangler with the 3.6L Pentastar has a documented left cylinder head failure that causes misfires, often with a check engine light for a single cylinder; it failed so often that Chrysler extended the warranty on the head. A persistent single-cylinder misfire on a 2012-2013 Pentastar that survives new plugs and a coil swap should be compression-tested for this fault.

Likely causes

  1. Left cylinder head valve seat failure (2012-2013 3.6L) → Shop the cylinder head at Amazon
  2. Worn spark plugs or a failed ignition coil (rule out first, far cheaper) → Shop the spark plugs at Amazon
  3. Fuel injector fault on the misfiring cylinder
  4. Carbon buildup or a vacuum leak (usually affects idle quality more broadly)

How to fix it — step by step

  1. Read the misfire code and identify the cylinder
  2. Swap the coil and plug with another cylinder and see whether the misfire follows them; if it stays on the same cylinder, the problem is in that hole
  3. Run a compression and leak-down test on the suspect cylinder
  4. A confirmed head fault is major engine work; ask a dealer whether the extended head coverage ever applied or was already used on your Jeep

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Jeep manual is on Jeep's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Jeep SUV Wrangler (JK, 2012–2013) problems

See all Jeep Wrangler (JK, 2012–2013) codes & guides →