iRobot Robot vacuum Roomba 800 Series Error 6
What this problem usually means
The cliff sensors are dirty or Roomba is stuck hanging over a cliff or on a dark surface: "Error six (6). Move Roomba to a new location then press CLEAN to restart."
Likely causes
- Dirty cliff sensors
- Roomba stuck hanging over a cliff
- Roomba on a dark surface
How to fix it — step by step
- Wipe Roomba's cliff sensors with a clean, dry cloth
- Move Roomba to a new location away from any drop or dark surface
- Press CLEAN to restart
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.