iRobot Robot vacuum Roomba 700 Series Error 1
What this problem usually means
Roomba is stuck with a side wheel hanging down: “Error one (1). Move Roomba to a new location then press CLEAN to restart.” One of the sprung side wheels has dropped off an edge or can't travel freely, and Roomba won't drive until both wheels are back on the floor.
Likely causes
- Roomba is stuck on an obstacle, or a wheel is hanging off a step, threshold or furniture edge
- Hair and debris packed into a wheel well, stopping that wheel from springing back down
- A wheel that no longer turns freely — debris wound around it, or a worn or damaged wheel
- A weak or broken wheel spring, or a failed drive wheel module — that wheel won't spring back or turns with different resistance than the other side
How to fix it — step by step
- Move Roomba to a flat, clear spot in the middle of the room, set it down with both wheels firmly on the floor, and press CLEAN to restart. If it cleans normally, it was simply stuck or a wheel was hanging off an edge.
- If Error 1 comes back on flat ground, flip Roomba over and push each side wheel up and down several times, shaking out any loose debris trapped in the wheel wells.
- Briskly turn both wheels by hand. Both must turn freely, spring back when pushed in, and offer the same amount of resistance — the wheel that sticks, grinds, won't spring back, or feels different from the other side is the problem wheel.
- Pull the front caster wheel firmly out of the robot and clear any debris from inside the wheel cavity; pop the wheel out of its housing, clear any hair wrapped around the axle, then snap it back in until it clicks.
- Set Roomba back down, confirm both wheels sit firmly on the floor, and press CLEAN to restart.
- If the error returns, replace the Drive wheel module on the problem side: flip Roomba over, remove the side brush (one screw) and the bottom cover, pull the battery out by its tabs, remove the three screws holding that wheel module, and lift the module out. The modules are labeled left and right and are mirror images of each other — fit the matching side, reassemble in reverse order, and press CLEAN to restart. If Error 1 persists with a new module, contact iRobot Customer Care. → Shop the drive wheel module at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Drive wheel module.
Parts that commonly fix it
- Drive wheel module - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.