iRobot Floor scrubber Scooba 380 Stuck in diagnostic mode (all lights cycling)
What this problem usually means
Scooba appears stuck in its factory/diagnostic test mode: the panel lights cycle continuously and it plays a melody when the battery is inserted. The documented cause is the Power/Clean switches stuck or contaminated by water ingress, so the robot reads a permanent button press.
Likely causes
- Water ingress contaminating the Power/Clean switch contacts
- A stuck or damaged button membrane
How to fix it — step by step
- Remove the battery and the charger and leave the robot for 24 hours to dry out (iRobot's advice in the thread)
- Do not cut into the button membrane - one owner damaged the panel doing this
- If drying does not clear it, the switch panel needs service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.