Hyundai SUV Tucson (TL, 2016–2018) Engine Knocking

What this problem usually means

The 2016-2018 Tucson's Theta II engines (and the 2.0L Nu GDI in the same years) can knock from connecting rod bearing wear caused by machining debris, progressing to an oil pressure warning and seizure. Hyundai extended rod-bearing engine coverage to 15 years/150,000 miles under TXXM and requires the Knock Sensor Detection System software (Campaigns 966/982) on most cars; a flashing check engine light with code P1326 is the KSDS telling you it has detected bearing wear.

Likely causes

  1. Connecting rod bearing wear from manufacturing debris
  2. Oil starvation after heavy oil consumption
  3. KSDS false trigger or knock sensor wiring fault (must be distinguished from real bearing wear) → Shop the knock sensor at Amazon
  4. Accessory or timing noise misread as a rod knock

How to fix it — step by step

  1. If the check engine light flashes, the car chimes and power is limited to limp mode, stop driving and have it towed — that is the P1326/KSDS pattern
  2. Check your VIN for the engine warranty extension and confirm the KSDS software was installed, since coverage can depend on it
  3. Check the oil level, but do not clear the code and keep driving on a knocking engine
  4. Have a dealer run the bearing inspection procedure (TSB 22-01-023H family) before paying for an engine anywhere else

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Hyundai SUV Tucson (TL, 2016–2018) problems

See all Hyundai Tucson (TL, 2016–2018) codes & guides →