Hyundai SUV Tucson (LM/TL, 2011–2018) Oil Consumption

What this problem usually means

Tucsons with the 2.4L engine from 2011-2018 burn oil at a high rate — the guide data notes Hyundai treats up to a quart per 1,000 miles as acceptable while many owners exceed it — with 2016-2018 Theta II cars the worst affected. There is no external leak to find: the oil passes the rings and burns, so the only warning is a falling dipstick until the level gets low enough to damage bearings.

Likely causes

  1. Piston ring sealing loss and carbon-stuck oil control rings → Shop the piston rings at Amazon
  2. Direct-injection carbon buildup aggravating ring fouling
  3. Valve stem seal wear at higher mileage
  4. PCV faults drawing oil into the intake

How to fix it — step by step

  1. Check the dipstick every 1,000 miles at minimum on a 2011-2018 2.4L car, and log how much you add between changes
  2. Rule out valve cover, pan and sender leaks so consumption is not confused with a drip
  3. Replace the PCV valve and re-measure before accepting an internal diagnosis → Shop the pcv valve at Amazon
  4. Ask a dealer to document consumption with Hyundai's test and check engine coverage for your VIN, especially on 2016-2018 cars
  5. Keep the sump full and shorten oil intervals while it burns; bearing failure on these engines usually starts as ignored consumption

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Hyundai SUV Tucson (LM/TL, 2011–2018) problems

See all Hyundai Tucson (LM/TL, 2011–2018) codes & guides →