Hyundai SUV Santa Fe Crankshaft position sensor failure
What this problem usually means
On the Santa Fe the crankshaft position sensor may fail, causing engine stalling or a failure to start; replacing the failed sensor commonly corrects the problem. It is the most likely cause of stalling on several 2014 Santa Fe units, and Hyundai released a technical service bulletin in October 2019 for the issue.
Likely causes
- failed crankshaft position sensor
- damaged sensor wiring or connector
How to fix it — step by step
- Note whether the engine cranks but will not start, or stalls suddenly while driving
- Scan for crankshaft position sensor fault codes such as P0335 → Shop the crankshaft position sensor at Amazon
- Check the sensor connector and wiring for damage or corrosion
- Replace the crankshaft position sensor and clear codes, then confirm the engine starts and does not stall
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the crankshaft position sensor.
Parts that commonly fix it
- crankshaft position sensor - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.