Hyundai Sedan Elantra (HD/MD, 2007–2015) Steering Wheel Clunk

What this problem usually means

On 2007-2015 Elantras the Motor Driven Power Steering (MDPS) column contains a small flexible rubber coupler that crumbles with age, producing a click, thud or clunk when you turn the wheel at low speed, plus extra play at the wheel. Hyundai extended the warranty on this coupling to 10 years/100,000 miles (bulletin 5NP-F8M5G-03 / TSB 17-ST-002 family).

Likely causes

  1. Worn or crumbled MDPS flexible rubber coupling in the steering column
  2. Loose steering column mounting or intermediate shaft wear
  3. Worn tie rod ends (usually clunks over bumps as well)
  4. Strut mount bearing wear when turning (creak/pop rather than a column clunk)

How to fix it — step by step

  1. Confirm the noise comes from the column, not the suspension: rock the wheel side to side with the engine on while parked and listen low in the dash
  2. Ask a Hyundai dealer to check the MDPS coupling warranty extension against your VIN before paying; many cars were repaired free
  3. If coverage has expired, the coupler itself is a cheap part (56315-2K000FFF) but the column/MDPS unit must come apart to fit it
  4. Have tie rods and strut mounts checked if the clunk also happens over bumps, since those are separate faults

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Hyundai Sedan Elantra (HD/MD, 2007–2015) problems

See all Hyundai Elantra (HD/MD, 2007–2015) codes & guides →