GE Washer WSL OE Error Code
What the OE code means
Water overflow error on GE WSL model washers (PartSelect): the washer detected an overflow condition.
Likely causes
- Water inlet valve not shutting off
- Failed pressure / water level sensor switch → Shop the pressure sensor switch at RepairClinic
- Wiring harness fault
- Control board fault
How to fix it — step by step
- Turn off the water supply to the washer immediately
- Disconnect power / unplug the washer
- Do not run another cycle until it has been checked
- Arrange service if water kept filling with the power off (stuck inlet valve) → Shop the water inlet valve at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the water inlet valve.
Shop the water inlet valve at RepairClinic or Amazon
Also tied to this fault: pressure sensor switch - Shop at RepairClinic or Amazon
Parts that commonly fix the OE code
- water inlet valve - Shop at RepairClinic or Amazon
- pressure sensor switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.