GE Washer IE Error Code
What the IE code means
Water level sensor error on GE WSL model washers (PartSelect). Note the same letters are used on newer GE washers as a Consumer Help Indicator for water not entering - check your model's manual.
Likely causes
- Failed pressure / water level sensor switch → Shop the pressure sensor switch at RepairClinic
- Loose or damaged wiring harness to the sensor
- Control board fault → Shop the control board at RepairClinic
- No water entering the washer (newer-model meaning)
How to fix it — step by step
- Press Power and check both water supply valves are on
- Unplug the washer for a few minutes, then retry once
- Make sure fill hoses are not kinked and inlet screens are clear
- If IE returns, the sensor, harness or board needs professional testing
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the pressure sensor switch.
Shop the pressure sensor switch at RepairClinic or Amazon
Also tied to this fault: wire harness - Shop at RepairClinic or Amazon; control board - Shop at RepairClinic or Amazon
Parts that commonly fix the IE code
- pressure sensor switch - Shop at RepairClinic or Amazon
- wire harness - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.