Dyson Air purifier Pure Hot+Cool Link HP02 E (solid)

What this problem usually means

A solid 'E' on the display means the machine has stopped functioning correctly.

Likely causes

  1. Room temperature at or below 5C
  2. Blockage in the inlet grille or loop amplifier outlet
  3. Filter blocked by excessive dust build-up or due for replacement
  4. Plug not firmly connected, or machine not switched on at the wall

How to fix it — step by step

  1. Unplug the machine and leave it for 10 seconds.
  2. Make sure the plug is firmly connected to the socket and switched on at the wall.
  3. Make sure the room temperature is above 5C.
  4. Check there are no blockages in the inlet grille or the loop amplifier outlet.
  5. Check the filter for excessive dust build-up within the inlet, and replace the filter if it is due.
  6. Test the machine: switch it off and unplug it, wait 10 seconds, plug it back in, switch the socket on, and press ON/OFF on the main body.
  7. Reset the machine: switch it off using the remote control or the main body, wait 60 seconds, then switch it back on - the fault code should clear.
  8. If the code persists, hard reset: switch the power OFF and unplug the machine (or switch off at the mains) for 30 seconds, then switch back ON - the error code should clear.

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Dyson Air purifier Pure Hot+Cool Link HP02 problems

See all Dyson Pure Hot+Cool Link HP02 codes & guides →