BMW SUV X1 (F48, 2016–2022) Engine mount failure
What this problem usually means
The second-generation X1 (F48, from 2016) is prone to early engine mount failures. Mounts typically need replacing at around 100,000 miles, but some X1s have needed them at under 20,000 miles; the upper mounts usually fail first, with the bottom mounts following. Signs are oil leaks from the mount, clunking and popping noises from the front, excessive vibration and the engine shaking too much.
Likely causes
- Upper engine mount failing early (fluid-filled mount leaking/collapsing) → Shop the engine mount at Amazon
- Lower engine mounts wearing with age/mileage
How to fix it — step by step
- Note clunking or popping from the front, excess vibration or visible engine shake
- Inspect the mounts for leaking fluid and cracked rubber; the right-side upper mount is the documented early failure
- Replace the failed mount(s)
- Re-check vibration and noise on a road test
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the engine mount.
Parts that commonly fix it
- engine mount - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.