BMW Sedan 5 Series (F10, 2010–2017) Rear Control Arm Bushings Worn

What this problem usually means

Rear lower control arm bushes are rated a very common wear item on the F10, typically deteriorating between 80,000 and 130,000 miles, and almost every F10 past 90,000 miles carries an inspection advisory for them. Symptoms are knocking from the rear over potholes, a loose-feeling rear end on sweeping roads, and uneven rear tyre wear as the geometry drifts. Left alone, the rear alignment moves, tyres wear early, and the car will eventually fail a safety inspection on the deterioration.

Likely causes

  1. Rear lower control arm bush rubber deteriorating with age and mileage
  2. Heat and road-salt ageing accelerating bush cracking
  3. Worn drop links or other rear joints adding to the knock
  4. Alignment drift from the bush wear wearing tyres unevenly

How to fix it — step by step

  1. Listen for rear knocking over potholes and check the rear tyres for uneven wear
  2. Have the rear bushes inspected on a lift; cracking and separation are visible, not a guess
  3. Replace both sides at the same time rather than chasing one knock
  4. Have a four-wheel alignment done after the arms are replaced
  5. Re-check tyre wear after a few thousand miles to confirm the geometry has settled

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related BMW Sedan 5 Series (F10, 2010–2017) problems

See all BMW 5 Series (F10, 2010–2017) codes & guides →