Blueair Air purifier Blue Pure 311 Auto / 411 Auto Air quality sensor cleaning

What this problem usually means

Documented maintenance guide: clean the air quality sensor when changing the main filter. The sensor inlet is at the back of the purifier.

Likely causes

  1. Dust build-up on the air quality sensor

How to fix it — step by step

  1. Turn the unit off and unplug it
  2. Carefully push the top cylinder down while rotating counter-clockwise to unlock, and remove the top cylinder
  3. Press the button on the inside of the unit to open the lid covering the sensor and remove the lid
  4. Gently clean the sensor with a cotton swab and reattach the sensor lid - do not use fingers or any unrecommended objects to clean inside the sensor inlet
  5. Push the top cylinder down while rotating clockwise to secure the lock, and plug in the unit

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Blueair Air purifier Blue Pure 311 Auto / 411 Auto problems

See all Blueair Blue Pure 311 Auto / 411 Auto codes & guides →