Audi SUV Q5 (8R, 2008–2013) Timing Chain Failure

What this problem usually means

Timing chain failure is a major documented problem on the Q5's 2.0 TFSI, per CarBuzz: Audi faced multiple class action lawsuits over models from roughly 2008-2013, a failed tensioner can let the chain jump and catastrophically damage the engine, and Audi repaired cars that fell within a specified list of VINs under the class action — this was a class action settlement, not an NHTSA safety recall, and owners outside the covered VIN list reported engine repair bills approaching $10,000.

Likely causes

  1. Timing chain tensioner failure allowing chain slack → Shop the timing chain tensioner at Amazon
  2. Timing chain stretch with mileage and extended oil intervals
  3. Chain jumping teeth and bending valves once tension is lost
  4. Guide wear contributing to chain noise before failure

How to fix it — step by step

  1. Listen for a metallic rattle on cold start at the front of the engine; that is the tensioner warning sign
  2. Check by VIN and service history whether the car was covered and repaired under the timing chain class action → Shop the timing chain at Amazon
  3. Have chain stretch measured with a VAG-capable diagnostic tool on any early 2.0 TFSI car
  4. Replace the chain, tensioner and guides preventively if stretch or rattle is confirmed; waiting risks the engine

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Audi SUV Q5 (8R, 2008–2013) problems

See all Audi Q5 (8R, 2008–2013) codes & guides →