Audi Sedan A4 Engine rattling on cold start

What this problem usually means

On B7 and early B8 A4s with the 2.0 TFSI engine, a rattling or ticking noise from the top of the engine on a cold start points to timing chain tensioner and guide wear. The tensioner's plastic slipper wears prematurely, the chain runs slack until oil pressure builds, and a slack chain can jump a tooth and seriously damage the engine. Audi issued updated tensioner parts as the fix.

Likely causes

  1. Worn timing chain tensioner with a plastic slipper that wears prematurely → Shop the timing chain at Amazon
  2. Stretched timing chain and worn chain guides
  3. Low oil pressure at startup from extended oil-change intervals

How to fix it — step by step

  1. Listen on a fully cold start: a rattle lasting a few seconds that fades as oil pressure builds is the classic symptom
  2. Scan for timing-related fault codes and check for rough running or an engine management light
  3. Do not keep driving and revving a car with a persistent rattle; a jumped chain can bend valves
  4. Have an Audi specialist measure chain stretch and inspect the tensioner and guides
  5. Replace the timing chain, tensioner and guides with the updated parts as a set → Shop the timing chain tensioner at Amazon → Shop the timing chain guides at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Audi Sedan A4 problems

See all Audi A4 codes & guides →