Audi Sedan A4 (B5/B6/B7/B8, 1996–2010) Suspension Clunking Noise
What this problem usually means
Some 1996-2010 A4 owners have reported clunking noises and a rough ride from prematurely worn suspension parts, per CarParts: affected drivers replaced lower rear control arms, control arm bushings, struts and driveshafts. Left unaddressed, worn suspension parts can cause uneven tire wear and steering alignment problems.
Likely causes
- Worn control arm bushings in the multi-link front suspension
- Worn control arms
- Worn struts → Shop the strut at Amazon
- Driveshaft or CV joint wear producing similar noises
How to fix it — step by step
- Note when it clunks — over bumps, turning, or accelerating — since each pattern points to different parts
- Inspect control arm bushings for cracking and play with the car on a lift → Shop the control arm bushings at Amazon → Shop the control arm at Amazon
- Check tire wear patterns; uneven wear supports worn suspension or lost alignment
- Replace the worn arms or bushings and have a wheel alignment done afterwards
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the control arm.
Shop the control arm at Amazon
Also tied to this fault: control arm bushings - Shop at Amazon; strut - Shop at Amazon
Parts that commonly fix it
- control arm - Shop at Amazon
- control arm bushings - Shop at Amazon
- strut - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.