Aiper Pool cleaner Seagull Pro Red light flashing
What this problem usually means
The red light keeps flashing and the device is not working: a fault — most often debris jamming the wheels, brush, or drainage motor, and Aiper's brush-resistance test can point to a faulty walking (drive) motor.
Likely causes
- Debris in the wheels, brush, or drainage motor blades
- Walking motor faulty — the roller brush turns with no resistance at all, or with very high resistance
How to fix it — step by step
- Turn off the device and clean the device's wheels, brush, and drainage motor blades, then restart and try again
- Turn off the device and manually turn the roller brush: some resistance is normal — if there is no resistance at all or the resistance is very high, the walking motor may be faulty
- If the problem persists after the above checks, contact Aiper support
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.