Acura SUV RDX (TC1/TC2, 2021) Driveshaft Separation — Recall
What this problem usually means
Safety recall 21V939 covers 2021 RDX: a front driveshaft component was improperly heat-treated and can fail, causing clunking, loss of drive power, or the vehicle rolling when parked if the shaft separates. Honda's remedy is free replacement of the affected left or right front driveshaft.
Likely causes
- Improper heat treatment of the driveshaft component
- Fatigue cracking at the weakened section
- Separation under driveline load
How to fix it — step by step
- Listen for new clunks on acceleration or when shifting between drive and reverse
- Check your VIN at nhtsa.gov/recalls for campaign 21V939
- Always set the parking brake until the recall is completed
- Have the dealer replace the affected driveshaft free under the recall
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the front driveshaft.
Shop the front driveshaft at Amazon
Also tied to this fault: cv axle - Shop at Amazon
Parts that commonly fix it
- front driveshaft - Shop at Amazon
- cv axle - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.