Acura SUV RDX (TC1/TC2, 2019–2021) Engine Loses Power in Rain — Limp Mode

What this problem usually means

2019–2021 RDX models with the 2.0L turbo (K20C4) can suddenly enter limp mode in rain or high humidity — power drops to roughly 25 mph with the check engine light flashing, then normal operation returns after a restart. Acura's TSB 20-053 attributes it to moisture accumulating in the intercooler; the fix is a PGM-FI software update plus redesigned intercooler and inlet/outlet pipes, and the bulletin has been revised four times through 2024 because the first fixes did not always hold.

Likely causes

  1. Moisture accumulation inside the intercooler
  2. Water ingestion upsetting the air/fuel calculation
  3. ECU protective limp-home strategy triggering
  4. Original intercooler pipe design trapping condensate

How to fix it — step by step

  1. Note the weather when it happens — limp mode in wet conditions is the signature
  2. Ask the dealer to apply the current revision of TSB 20-053: software plus intercooler and pipe replacement → Shop the intercooler at Amazon
  3. After an episode, a restart restores power, but get the TSB done rather than living with it — highway power loss is a safety issue
  4. Document repeat episodes with dates and repair orders if the problem returns after the TSB

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Acura SUV RDX (TC1/TC2, 2019–2021) problems

See all Acura RDX (TC1/TC2, 2019–2021) codes & guides →