Acura SUV MDX (YD8/9/YE1, 2022–2025) Engine Stalls After Stopping — Fuel Injector ECU Recall

What this problem usually means

Safety recall 25V031 covers 2022–2025 MDX Type S (and 2021–2025 TLX Type S): a software error in the fuel injection ECU can stall the engine as the vehicle stops or idles. The remedy is a free dealer software update to the FI-ECU — no parts are replaced.

Likely causes

  1. FI-ECU software calibration error
  2. Incorrect idle fuel control after deceleration
  3. Software fault triggered at stop or idle

How to fix it — step by step

  1. Check your VIN at nhtsa.gov/recalls for campaign 25V031
  2. Book the free dealer software update
  3. Until updated, expect stalls only at stops or idle and restart promptly in neutral
  4. Verify the update on the repair order

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Acura SUV MDX (YD8/9/YE1, 2022–2025) problems

See all Acura MDX (YD8/9/YE1, 2022–2025) codes & guides →