Acura SUV MDX (YD3/4/7, 2018–2019) Timing Belt Teeth Separation — Recall
What this problem usually means
Safety recall 19V298 covers 2018–2019 MDX with the 3.5L V6: teeth can separate from the timing belt because of a contaminated belt compound, causing stalls, misfires, or — on this interference engine — severe internal damage if the belt jumps. The recall remedy is a free timing belt replacement with engine inspection.
Likely causes
- Contaminated timing belt tooth compound → Shop the timing belt at Amazon
- Tooth delamination under load
- Heat-accelerated belt degradation
How to fix it — step by step
- Treat stalls or misfires as urgent — a jumping belt bends valves
- Check your VIN at nhtsa.gov/recalls for campaign 19V298
- Have the dealer replace the belt free under the recall
- Ask for the tensioner and water pump to be inspected while the belt is off → Shop the water pump at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the timing belt.
Shop the timing belt at Amazon
Also tied to this fault: timing belt tensioner - Shop at Amazon; water pump - Shop at Amazon
Parts that commonly fix it
- timing belt - Shop at Amazon
- timing belt tensioner - Shop at Amazon
- water pump - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.