Acura SUV MDX (YD3/4/7, 2016–2020) Engine Stalls or Knocks — Connecting Rod Bearing Recall
What this problem usually means
Safety recall 23V751 covers 2016–2020 MDX (and 2015–2020 TLX V6): manufacturing debris in the crankshaft can wear the connecting rod bearings until the engine knocks, stalls, loses power, or fails outright. Honda's free remedy is dealer inspection with repair or engine replacement as needed — the same campaign that covers the TLX, applied to the MDX's 3.5L V6.
Likely causes
- Manufacturing debris in the crankshaft journals → Shop the crankshaft at Amazon
- Progressive connecting rod bearing wear
- Resulting loss of oil pressure and bearing seizure
How to fix it — step by step
- Stop driving on deep knock or an oil pressure warning — bearing failure destroys the engine quickly
- Check your VIN at nhtsa.gov/recalls for campaign 23V751
- Book the free dealer inspection and keep the outcome paperwork
- If the engine was replaced, confirm the new engine's serial is recorded on the repair order
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the connecting rod bearings.
Shop the connecting rod bearings at Amazon
Also tied to this fault: crankshaft - Shop at Amazon; engine oil - Shop at Amazon
Parts that commonly fix it
- connecting rod bearings - Shop at Amazon
- crankshaft - Shop at Amazon
- engine oil - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.